General Boards > Technical Support

Identify an Entry Door Awning

<< < (2/3) > >>

Joel Ashley:
The model shown in the attached link doesn't match mine precisely, which has a tubular motor mounted horizontally in the unit, but I wish it did.  But it may match yours, Neal, as engineering fluxed in that era.  The tubular motor has to slide out sideways from within the awning and the adjoining big awning won't allow that.  But this video reveals a lot of similarities that prove enlightening.  Thanks, Fred, for refreshing my review of current video offerings;  there may be others I haven't yet explored.  Hopefully Neal will find this or another one to be the answer to his situation.
https://www.youtube.com/watch?v=KHA7MAzzxcA

If you run across one specific to tubular motor models before I do, Neal, please advise ;).

Joel

Steve Huber:
Neal, Fred,
Per the 2005 Monterey Owners Manual in Coach Assist, the over the door awning was an option and is listed as an 'Eclipse Automatic Carefree".
Steve

Fred Brooks:
  Steve,
  When I saw the picture that he posted, I saw the protruded part of the motor housing and made the incorrect statement. You are correct, it is the "one touch eclipse" I apologize for the mistake. Fred

Steve Huber:
No need to apologize. We are all trying to help each other. :)
Steve

David T. Richelderfer:
Neal - I am wondering if you were able to remove and/or dismantle your over-the-door awning.  After arriving in Yuma for the winter about 2 1/2 weeks ago, I decided to tear into my over-the-door awning because it has not operated at all for several years.  I have not been able to precisely identify the awning other than knowing it's a Carefree of Colorado unit.  Yesterday I spent a couple of hours getting the end cap off the motor and was able to successfully remove the awning completely from the coach.

The motor has to be completely removed from the end of the awning in order to allow the awning to extend.  Once extended about a foot or more, the three screws locking the awning into place on the coach can be removed.  Then the awning can be tilted up and slid off the front from the holding rail.

My awning motor appears to be a dead soldier but has no identifying name, model, or any identifying information.  My next step is to either repair the motor, if indeed repairable, or replace it.  My next stop will be to see "Old Bob" at CJ's RV Repair here in Yuma tomorrow.  I will take the awning and motor to him to see if he can repair or replace the motor and reinstall it.  If so, then I can slip the awning back in place, hook up the wires, apply liberal amounts of Lexel at the leak points,  and reinstall the three screws that hold it from sliding left or right, or lifting in the wind.

Anyone know where I can get a motor for it?  I understand it's a Fiamma motor.

BTY - Once you have spent a few hours trying to figure out how to get the awning extended, you will find it pretty easy to reinstall... I think!  There is one screw that must be removed and it's under the front flap that leads the awning out when it extends.  The problem is that screw is under that flap.  Well... a two-inch section of that flap can be removed by removing the screw that holds it in place.  You have to drive a wedge horizontally under the flap from its left side.  Then look in horizontally from the left side.  There you will see a Phillips head screw to remove.  Removing that screw will allow that two-inch piece of the flap to come off revealing the final screw that holds the motor cover on.

Navigation

[0] Message Index

[#] Next page

[*] Previous page