Hello all: I have a question or two. I have searched through the forums and learned a lot but I am still having trouble. My fresh water fill shuts off I believe before it is full. The Aladdin says about 48%. If I go to the "raw" data it shows a number of about 34. From doing research I should have a full raw number in the 70's that would equate to about 95%full in normal mode.
1. Is there a way to manually open the fill valve without jumping it ?
2. Is there a way to trick the Aladdin into not shutting it off until it overfills?
If I can get the tank full then I can set the full calibration from there, but I don't think it is full. Any help on this will be greatly appreciated. I am not too worried about the gray and black tanks. I just want to make sure I can get a full load of fresh water.
Thanks, Dan
2003 Marquis