Author Topic: Tri Mark door control board location  (Read 2654 times)

Paul Aronson

  • BAC Member
  • *
  • Posts: 76
  • Thanked: 16 times
Tri Mark door control board location
« on: November 22, 2021, 09:50:23 PM »
I have a 2007 Patriot Thunder and want to change the door open/lock code.
Does anybody know physically where the control board is located? It is NOT behind the passenger side cabinet next to the seat. I have the instructions but need to jumper two pins together and need to locate the control board.
2007 Beaver Patriot Thunder Winchester III
45' C-13 525 Hp
2013 Chevy Traverse

Gene Obie

  • BAC Member
  • *
  • Posts: 156
  • Thanked: 36 times
Re: Tri Mark door control board location
« Reply #1 on: November 23, 2021, 04:51:10 PM »
My programming button is behind access panel below magazine rack. See pic.


For programming the FOB there black box under the dash... sitting in drivers seat there's a black box with bundle of wires (+switch + LED) mounted under and to the left of the instrument cluster (on the sidewall to the left of my left foot). I accessed this when programming some extra FOB's.

These various posts always motivate me to tackle something on my  todo list. My coach has had default factory code since I purchased and probably since it was new. I finally changed it today :)
« Last Edit: November 24, 2021, 12:11:51 AM by Gene Obie »
-Gene

2005 Beaver Marquis, Ruby 40, C-13 Cat 525HP, Allison 4k
Towing 2018 F-150
Washington
The following users thanked this post: Frank Bergamo

Gene Obie

  • BAC Member
  • *
  • Posts: 156
  • Thanked: 36 times
Re: Tri Mark door control board location
« Reply #2 on: November 24, 2021, 12:13:42 AM »
Here's a picture of the module under the dash for programming FOBs.
-Gene

2005 Beaver Marquis, Ruby 40, C-13 Cat 525HP, Allison 4k
Towing 2018 F-150
Washington
The following users thanked this post: Frank Bergamo

Paul Aronson

  • BAC Member
  • *
  • Posts: 76
  • Thanked: 16 times
Re: Tri Mark door control board location
« Reply #3 on: November 24, 2021, 02:01:13 AM »
Thank you. Will check there
2007 Beaver Patriot Thunder Winchester III
45' C-13 525 Hp
2013 Chevy Traverse

Scott Shearer

  • BAC Member
  • *
  • Posts: 169
  • Thanked: 68 times
Re: Tri Mark door control board location
« Reply #4 on: November 24, 2021, 09:03:12 AM »
Not sure that is the controller you are looking for, but on our 06 PT it is mounted on the back wall of the front run bay. I believe that it is for the Key FOBs (as Gene referenced).

-Scott
Scott & Susie Shearer
2006 Patriot Thunder
Lexington IV 40'
Cat C13
2015 JKU Hard Rock

Mike Shumack

  • Guest
Re: Tri Mark door control board location
« Reply #5 on: November 24, 2021, 03:37:08 PM »
OP said he want to change door lock "code" so that would not be the "black box" controller the above posts are showing. The key FOB controller is different from the door keypad controller.

Do you have the Grab Handle style with the built-in keypad?
If so, the controller is built into the handle. You need to access the wiring (there would be a removable panel on the inside of coach) and there will be a single wire (yellow) that is not connected to anything that needs to be grounded - or the factory could have installed a momentary push button to connect the yellow to ground). That wire needs to be grounded to put the keypad in program mode.

If you don't have the Grab Handle style - forget what I said above