Hello everyone and hopefully everyone is feeling okay now that the election is over . We have a 2000 Beaver Patriot Ticonderoga, and a Hurricane heater . I’ve replaced the fuel filter and the air filter, I also replaced the fuel nozzle, the flame sensor and the igniter. Going into the fuel nozzle and flame sensor area is 4 wires coming in . Before I started any work I labeled all the wires as I removed them one at a time . There’s only 4 wires coming into there . As I was removing the wires there was one purple wire that appeared to have just broken off, there were no bare wires coming out of the insulation , so I don’t know if that is a ground wire or where that booger lands . Everything should be ready to go start, would anyone happen to know where that wire might go . And I have a few alarms on the panel next to the heater, I believe flame out, and another one that says something about electrical . Any help would be greatly appreciate, it’s really a well made heater and I’d love to have it working . I would like to add, it had worked for us a few times, and when I started working on it, I couldn’t believe how much carbon was on the fuel nozzle, no wonder it wasn’t working . Thanks for any help .