The battery hold down system on our coach has been problematic since we got it in 2006. I'm sure I'm not the only one who's experienced these issues, and am wondering what others have done about it.
I try to keep the tray and batteries clean and the cable connectors free of sulfur bloom and corrosion. The nylon strap hold down system though is tougher to deal with. The screws that mount the strap ends to the tray bloom and corrode in spite of my attempts to retard their deterioration, and are difficult to clean and treat because you have to remove the batteries to do a proper job of it. I've even slipped those red and green felt battery post anti-corrosion rings down over the strap fittings, but the screws still rust. Stainless screws will be my next move there.
The biggest headache though is the quick-connect buckles on the nylon straps. The original equipment plastic ones actually melted. Apparently acidic fumes must creep down the strapping and concentrate at the bottom where it mounts to the buckle/connector. The nylon straps themselves incur no harm, but the male upper connector halves connected to them literally melt!
So I searched hardware stores left and right and finally found some chromed 1 inch metal quick connect buckles at a Coastal ranch supply store in the horse harness dept. A niece we were visiting last summer sewed the female half onto the tray side strapping, just like the original plastic one was configured, one for each of my two sets of straps. I then sprayed the new metal connectors with Permatex battery post anti-corrosion paint, though it didn't cover chrome very well.
Son of a gun the other day I went to clean the batteries and check acid levels, and one of the male halves of the new buckles was shot. The only place it corroded was where the long strap wrapped around it's slots; almost totally eaten away and covered in white bloom. The squeeze nubs and the rest of the buckle half were unmarred and fully functional, still clean and paint entact. Only where the nylon strap figure eighted around the slots did it rot away. The nylon clean as a whistle; but obviously fumes must condense on the strapping where it crosses over battery tops, and leach down, concentrating where the strap winds around the connector half. The sewn-in female buckle half attached to the tray is unaffected.
Now I find Coastal doesn't sell that chrome connector anymore, but I'm gonna keep looking, and if I find one I will super-coat it with anti-acid paint and try again. I'd try stainless if such a buckle was made, but acid might get to it as well.
One shouldn't have to rinse and dry one's strapping once a week to deal with this annoyance. I've either got to halt the leaching down the strapping somehow, or find a better or more resistant buckle/connector system. Anyone else successfully dealt with the issue?