Been searching the board trying to find in the aqua hot questions something relating to the F fuse, when I hit the switch to turn on the hot by the count of two, I’ve blown that breaker when I jumped the ignition underneath, so I could actually listen it sounds like the blower engages for you up to the count of two. After reading the aqua manual over and over the different things that could be none of them seem to address this issue most the troubleshooting needs to have power on. I’ve checked continuity on all the VDC and the VAC the electric water heater probe. Everything works fine. I’ve got power to the C2 plug so I’m kind of lost. My next step was, I pulled the blower and motor out. Got it on the bench with 12 V power when the motor is hooked up to the blower shaft, it will not run constantly if I disconnect the motor from the shaft, the motor runs with no Interruptions. When it was running connected to the blower shaft, the bearings didn’t sound good so I’m gonna go ahead and break that apart and change the bearings and I’m wondering if there is a way to check the resistance on that motor to make sure that it doesn’t fail under a load. Should I take it to motor shop?
I’ve contacted the Aqua hot on Tuesday and put in a submission for technical support. I haven’t heard anything back from them. I’ve contacted to authorized reps in the southwest Washington area area. I haven’t heard back from them so maybe somebody out there can put me in a direction I don’t mind putting the bearings in. I’m sure that’s a good good move anyhow at this point it’s life. I’ve had about seven years and never changed them, but even then, I’m not sure if that’s gonna solve the problem any help I’d appreciate it