Been a while due to work schedules and holidays etc.
But wanted to update the problem with no Lo Beam ( blows fuse#69 ) when plugged in to circuit.
So we have continuity through the steering column Dimmer switch and can cycle Hi to Lo beam and get continuity to terminal connectors at base of steering column. So I'm taking the dimmer switch out of the equation as it seems to work as intended.
I just tested R-11 relay and its functioning as intended.
I'm now getting a little confused as to the circuitry as it appears to be running in parallel with a sub-circuit being powered by the VIP switch on the steering wheel?
Looking at the schematics, I see pin 87 is open and 87a is closed and feeding the dimmer switch. Only when the the VIP switch is pressed does the power switch across the 87 and 87a pins. But the Hi and Lo beam are still only activated using the dimmer switch.
So am I making this too complicated? I need to figure out how to test circuit continuity from VCB 11 to the headlight connector but it looks like it's not a hot circuit unless the VIP switch AND the Dimmer switch are in agreement.
I still have an open circuit due to me pulling apart the terminal connector at the steering column so I don't blow fuse #69, but is the circuitry from the dimmer switch going to R-11 relay first or VCB connector.??
I'm wondering if I pull the VCB connector out and select Lo beam if it will blow the fuse or not. At least them I'm getting further downstream to where I may have a short?
Thanks for the help.
