« previous next »
Pages: [1]   Go Down

Author Topic: Vorad  (Read 23 times)

Michael Hammer

  • BAC Member
  • *
  • Posts: 2
Vorad
« on: Today at 01:49:54 AM »
Hello. I have a 2008 Beaver Marquis. I was hoping someone would know the location of the Eaton Vorad EVT 300 CPU. I believe it has failed and would also like to knwo if anyone has a suggestion on replacement or repair. Thank you
Logged

Frank Bergamo

  • BAC Member
  • *
  • Posts: 321
  • Thanked: 92 times
Re: Vorad
« Reply #1 on: Today at 02:44:23 AM »
On my 07’ Marquis, it is located inside the left side switch cluster just to the left of the pilot seat. As of know, there are none available. Rick Youngblood was the go to, but last I heard, all of his stock is gone. I have replaced mine twice, so knock on wood, it keeps working. You can get the Cruise Control to work if you cycle the on/off switch 3 times, but the Collision Avoidance System will not work. Not the news you wanted to hear, but at least the CC will still operate. Good luck!
Logged
Frank & Paulette Bergamo
2018-       : 2007 Marquis Topaz IV  C-15 600 HP Allison 4000
2014-2018: 2002 Marquis Emerald C-12 505 HP Allison 4000
2004-2014: 1986 Executive Diplomat 3208 250 HP Allison MT-643
Grand Junction, CO.

Michael Hammer

  • BAC Member
  • *
  • Posts: 2
Re: Vorad
« Reply #2 on: Today at 06:06:42 AM »
Hi Frank. Thanks for the prompt reply. I did send Rick an email earlier hoping he could help. Haven't heard anything yet. I thought I looked thoroughly for the cpu where it should be but I didn't see it. I'll look again tomorrow morning. Beaver coach sales, Mike thought it was located elsewhere but couldn't remember where.  I see numerous units on ebay but assume they would need specific re-programming. That might kill the project. Did you need to reprogram your 2 units? Any other thoughts would be appreciated. Take care. Mike
Logged
Pages: [1]   Go Up
« previous next »